A 20 cm diameter acrylic dish being trimmed with a circular saw.
A 20 cm diameter acrylic dish being trimmed with a circular saw in the Powermatic/Burke Millrite.
The dish is held on a Bridgeport 12" rotary table by an aluminum crossbar with a center resting in a plywood plug inside the dish.
A laminated plywood riser provides clearance above the Bridgeport table for the stub arbor holding the 3" x 1/16" Butterfield saw.

A 10 cm diameter acrylic dish being parted in the Logan lathe.
A 10 cm diameter acrylic dish being parted in the Logan lathe.

A closer view of the parting operation.
A closer view of the parting operation.

email info at easthope dot ca
Copyright © 2010, Peter Lyall Easthope. All rights reserved.

Valid CSS! HTML5 conformance

Best viewed with a Web browser.




HTML.Compile * ~ Desktops.OpenDoc SpecimenVessels.html ~ ET.OpenAscii SpecimenVessels.html FTP.Open "easthope@easthope.ca" FTP.PutFiles SpecimenVessels.html => "/public_html/SpecimenVessels.html" ~ FTP.Close